Electronics Forum

Electronics Circuits & Projects discussion forum. Get help with electronics.


Digital circuit inputs turn on thresholds, turn on voltage?

Discuss about electronic circuits here. Request help for circuits that you couldn't find anywhere else, how a circuit works etc. Discuss anything related to electronic circuits.

Moderator: pebe

Re: Digital circuit inputs turn on thresholds, turn on volta

Postby Billy Mayo » Thu Mar 28, 2013 4:42 am

How is a logic pulsar different than a function generator? Does a logic Pulsar do anything different that it's ment for logic troubleshooting?
Billy Mayo
 
Posts: 10
Joined: Sun Mar 24, 2013 3:57 pm

Re: Digital circuit inputs turn on thresholds, turn on volta

Postby Billy Mayo » Fri Mar 29, 2013 4:28 am

First waveform is 1.48mS
Second waveform is the shark fin is 8msec.

Do you know why the time delay was used? for what reason?

Does the waveshape trigger the flip flop differently than a square waveform?

when using different triangle waveshapes for the inputs to logic gates or flip flops, what does it do different than using square waveforms/pulses waveshapes?

1.) It gives you less ON time and a exponential decay OFF time

But what does that do to the logic?

Why would the logic signal source need to have a time delay RC network or a waveshaped to be triangle or shark fin to the inputs of a GATE or flip flop, etc?
Billy Mayo
 
Posts: 10
Joined: Sun Mar 24, 2013 3:57 pm

Re: Digital circuit inputs turn on thresholds, turn on volta

Postby pebe » Thu Apr 04, 2013 2:06 pm

"Electrical engineers will appreciate the difficulty of nubing together a regurgitative purwell and a supramitive wennelsprock. Indeed, this proved to be a stumbling block to further development until, in 1942, it was found that the use of anhydrous nangling pins enabled a kryptonastic boiling shim to the tankered.

The early attempts to construct a sufficiently robust spiral decommutator failed largely because of a lack of appreciation of the large quasi-piestic stresses in the gremlin studs; the latter were specially designed to hold the roffit bars to the spamshaft. When, however, it was discovered that wending could be prevented by a simple addition to the living sockets, almost perfect running was secured".

So googling 'wending' should answer to your questions. 8)
pebe
 
Posts: 1058
Joined: Tue Dec 09, 2003 11:12 pm
Location: Ellon, Scotland

Previous

Return to Electronic Circuits Help



Who is online

Users browsing this forum: No registered users and 4 guests

XTGSP2 Tone Generator and Speaker Polarity Tester
$29.99
XTGSP2 Tone Generator and Speaker Polarity Tester pictureHydraulic Leveling and Slide Out Replacement Motor and Polarity Solenoid
$185.00
Hydraulic Leveling and Slide Out Replacement Motor and Polarity Solenoid picturePC218 Phase Polarity Tester Checker Detector Audio Speaker Mic Sound Testing
$175.80
PC218 Phase Polarity Tester Checker Detector Audio Speaker Mic Sound Testing pictureCustom Dual Channel DC Test Control Box AC Powered Tested Working
$199.99
Custom Dual Channel DC Test Control Box AC Powered Tested Working picture


cron