On eBay Now...

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Reference / Harness Number: 104-300-0004
This listing is for one used Clever Devices red LED dot-matrix message display from commercial transit-bus surplus inventory.
Clever Devices specializes in Intelligent Transportation Systems and passenger-information technology for public-transit fleets. Its onboard systems integrate items such as passenger-information displays, automated announcements, destination signage and other vehicle electronics through its IVN architecture.
The unit features a full-length red LED matrix housed in a heavy-duty black extruded-aluminum enclosure designed for commercial transit use.
Electrical / Control ConnectionsThe wiring and terminal area are labeled with:
+12/24V
DATA A
DATA B
GND
The assembly also incorporates:
The 12/24V marking indicates the unit is designed around a low-voltage DC vehicle electrical system, but I would not state exact allowable voltage range or polarity beyond what is physically marked.
CommunicationThe presence of DATA A / DATA B suggests a differential serial communication network.
However, I would remove “RS-485” from the listing unless Clever Devices documentation or the circuit board specifically identifies the protocol as RS-485.
DATA A/B wiring often indicates that type of network, but it isn\'t enough by itself to guarantee the protocol.
Use this instead:
Communication: Differential Data A / Data B interface
That is completely defensible from the labels.
Clever Devices Transit ApplicationClever Devices’ onboard passenger-information platforms are specifically built for transit environments. Its current product lineup includes onboard digital signage, automated voice-annunciation systems synchronized with LED signage, IVN vehicle hardware and other passenger-information systems.
Public transit documentation also describes Clever Devices’ IVN as interfacing with interior signs and headsign systems, reinforcing the transit application of this type of hardware.
Likely use would therefore be:
Transit bus interior passenger-information / message display
I would not call this an exterior destination headsign unless its original mounting location is known. The relatively narrow enclosure looks more consistent with an interior information display, but that is something I would keep conservative.
Part Number NoteThis is important for your listing:
104-300-0004 appears to be a harness/reference number.Since that number is stamped on the Clever Devices wiring harness rather than clearly identified on the display housing as the display assembly MPN, I would list it as:
Reference Number: 104-300-0004
rather than:
Manufacturer Part Number: 104-300-0004
For \'s required MPN field, if there is no other number physically present on the display, I would use:
Does Not Apply
Then put 104-300-0004 prominently in the title and description so it remains searchable.
That is safer than representing a harness number as the complete sign\'s official MPN.
DimensionsYour draft says both 30–38 inches and then mentions ruler photos closer to 28–30 inches.
I would not publish either number until you take one straight tape measurement from end cap to end cap.
For now:
Overall Length: See photos / measurement to be confirmed
Housing cross-section, if your caliper readings are clear:
Approx. 4.03\" H x 2.46\" D
Condition DetailsUSED / UNTESTED
This unit was removed from transit-related surplus inventory.
Visually:
Normal scratches, dust, marks and other cosmetic wear should be expected from previous service and warehouse storage.
The unit has NOT been powered or tested.No representation is made regarding:
This is not a standalone consumer LED sign.
It was designed as part of a vehicle/transit information system and may require:
to display messages.
That disclaimer is valuable because someone may otherwise buy it expecting to simply connect 12V and type text into it.
ShippingWrap the entire aluminum housing in foam or bubble protection, with additional protection at both end caps.
Because the LED lens runs nearly the full length, use a rigid double-wall shipping carton and avoid allowing pressure directly against the display face.
Returns30-day returns accepted. Buyer pays return shipping.
Unit must be returned in the same condition received and without modification, disassembly or installation damage.
****WS1D****

Clever Devices Red LED Transit Bus Message Display 12/24V 104-300-0004
$82.20
Clever Devices Wiring Harness 118-300-0219FD-TX NOS
$31.51
CLEVER DEVICES CD-10 05920137 Circuit Board Used With Warranty
$49.99
![]()
Popular Tutorials
Alarms and Indicator Circuit diagrams